Search for:

Sign in Sign up

Search for:

Sign In

Home » 06 Model manually rebars

06 Model manually rebars

0% Complete

0/0 Steps

Quiz 1 of 0

06 Model manually rebars

Sten Tuudak 12.04.2025

Time limit: 0

Quiz Summary

0 of 5 Questions completed

Questions:

Information

You have already completed the quiz before. Hence you can not start it again.

Quiz is loading…

You must sign in or sign up to start the quiz.

You must first complete the following:

Results

Quiz complete. Results are being recorded.

Results

0 of 5 Questions answered correctly

Your time:

Time has elapsed

You have reached 0 of 0 point(s), (0)

Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)

Categories

Not categorized 0%

1
2
3
4
5

Current
Review
Answered
Correct
Incorrect

Question 1 of 5

1. Question
What are the outcome/result differences between creating a rebar group VS many single rebars? Which one should we prefer usually?
- This response will be reviewed and graded after submission.
Grading can be reviewed and adjusted.

Grading can be reviewed and adjusted.
Question 2 of 5

2. Question
Some rebars are invalid (small/thin line visible) in the model. What can be the reason? There are two possible reasons for that.
- This response will be reviewed and graded after submission.
Grading can be reviewed and adjusted.

Grading can be reviewed and adjusted.
Question 3 of 5

3. Question
How can you change the standard hook length? I know two ways of doing that.
- This response will be reviewed and graded after submission.
Grading can be reviewed and adjusted.

Grading can be reviewed and adjusted.
Question 4 of 5

4. Question
How can you move or delete some rebars from rebar group? I will tell you three different ways of doing that.
- This response will be reviewed and graded after submission.
Grading can be reviewed and adjusted.

Grading can be reviewed and adjusted.
Question 5 of 5

5. Question
Order steps to model a rebar group with different zones where each zone spacing must be exact/precise.
- Divide into different zones (with Direct Modification ON you can select the group and set the zones).
- Model one rebar group with the same rebar spacing.
- Set exact spacing numbers (select the group and from the Properties you can set them)
- Set each zone rebar spacing (with Direct Modification ON you can set them).
View Answers:
Correct

Incorrect